Forum

@ryf After reboot, this register must be 0x00. Normally the PIco should re-boot itself after that command, and flashing 3 times with LEDs. The pr...

@ryf After that command it is automatic stored in the MCU EEPROM, without any action from your side. It will restart the PIco and it will be visi...

Hi, Have you solved it ? Just to close the thread My Best Regards PiM

@ryf Hi, This is not a problem of other device, seems that there is an address overlapping. Both devices are good. The solution is to change th...

NOTE: Please remember to remove ANY other hardware before we make it working properly. WHen we make it to work, you are free to add whatever you like ...

Hi, Page 96 in the manual (or close to this page number) depending to what version of manual you have. 1. Make sure your system is Cable Powered (...

@ryf Hi, Please follow my recommendation on next post I sent and inform me about My Best Regards Pi Master

@ryf Hi,Close to be impossible as all other I2C PIco addresses are visible. So, that means the I2C PIco interface is working well. Can you please d...

Hi, Please decrease the speed of the I2C on the Raspberry Pi. -------------------------- Decreasing the Raspberry Pi I2C rate The Raspberry Pi...

Hi, You need to decrease the speed of the I2C to lower rate, i.e. 25K. Please advise The I2C pull-up resistors are on the Raspberry Pi PCB and not...

@kaif Hi, We still have a problem with hundreds (many hundreds) per day of dummy posts or registration from various bots. Please if you send a po...

Yes, Yes, just overloaded with new PIco 5 production and firmware BR PiM

Hi, This script has been written (by the way by CHATGTP and polished by us), in order to simplify changes of the PIco registers. As most of the peop...

Please send me picture (screen shot) to have better view BR PiM

@kaif Hi, It has been not released yet. However the script is proper and working also with 0x0179. Until we release the 0x0180 please edit the sc...