Forum

@ryf Hi, The most possible is that it is good. You must be doing something wrong. Are you available today to work together, again. If for any...

@ryf Hi, You do not need these resistors. They are existing already on the Raspberry Pi PCB. BR PiM

@ryf If you have PIco alone without any other hardware ? Or both together ? Please advise BR PiM

@ryf Hi, Yes, I see Let me think and answer tomorrow. Very impossible to have it broken Where are you located physically BR PiM

Hi, I made a simple test of mapping and it is working well See attachment. sudo i2cset -y 1 0x6b 0x18 0x01 (0b00000001) Mapping of System SYS L...

Hi, I will answer in details tomorrow evening, after setting of the workbench. My Best Regards Ioannis

@s3000 Hi, 🙂 www.ccsinfo.com PCD version The most compact and fastest, even better that Microchip. We have the full one, but a...

Hi, I will try to answer as much a s possible. It is ready a long time already, just adding and adding new features before release it. We wa...

@ryf Hi, Yes, your firmware is very old. However as it is a vital part of the system, it was implemented and working from the beginning. Yes, Ple...

Hi, As I said, tested now and it is working well. On every change we have a LEDs information to the user, called "walking led" that means lighting L...

@ryf After reboot, this register must be 0x00. Normally the PIco should re-boot itself after that command, and flashing 3 times with LEDs. The pr...

@ryf After that command it is automatic stored in the MCU EEPROM, without any action from your side. It will restart the PIco and it will be visi...

Hi, Have you solved it ? Just to close the thread My Best Regards PiM

@ryf Hi, This is not a problem of other device, seems that there is an address overlapping. Both devices are good. The solution is to change th...

NOTE: Please remember to remove ANY other hardware before we make it working properly. WHen we make it to work, you are free to add whatever you like ...