Forum

Additionally, could this info help in adjusting the RTC procedure: RTC Link

I understand what you are saying, however I have "kiosk" holes in my wall prepared which only have CAT6A connections. These CAT6A are powered by HP/Ar...

Well, as I had a little time at my hands. I switched the power supply. Initially I used a Samsung 5v @2A, which did not work (suspected by you) Th...

The screen only does: Power requirements: 200mA at 5V typical, at maximum brightness. Which is quite low (and reason I picked the RPI one). RPI ...

Oke, forgot I connected the RPI 7"touch again. This morning disconnected the powerpin on 5V and system booted and stayed online: #raspberrypi:~/...

So news from my sides, batteries are fully charged and tested. Just installed and rebooted, was able to pull a status page: #raspberrypi:~/PiM...

@piadmin Well, I can understand as I almost threw it horizontally against the wall 🤣 🤣 🤣 But then I thought, it should be O...

@piadmin hmz, okay, well we wil test this afternoon when the cycle is finished. However this is quite odd as normally people purchase these batteries ...

No worries, this morning I have put the 18650 in my MC3000 charger and they will do a CDC session. After they will be fulland capacity confirmed (th...

On a fresh Rasbian Lite 64bit image (previously I had a 8gB which needed to be replaced anyway): #raspberrypi:~/PiModules $ sudo python pico_i2c3.py...

Do you mean an rasbian image on this link: I have looked, but could not find any only firmware, status i2c etc. Am I missing something?